Vortex motion induced losses in tantalum resonators
Published in Physical Review B, 2026
Citation: Faranak Bahrami, Matthew P. Bland, Nana Shumiya, Ray D. Chang, Elizabeth Hedrick, Russell A. McLellan, Kevin D. Crowley, Aveek Dutta, Logan Bishop-Van Horn, Yusuke Iguchi, Aswin Kumar Anbalagan, Guangming Cheng, Chen Yang, Nan Yao, Andrew L. Walter, Andi M. Barbour, Sarang Gopalakrishnan, Robert J. Cava, Andrew A. Houck, Nathalie P. de Leon, "Vortex motion induced losses in tantalum resonators", Physical Review B 113, 054505 (2026). https://doi.org/10.1103/4ny9-9n5b
Abstract: Tantalum (Ta)-based superconducting circuits have been demonstrated to enable ultrahigh qubit quality factors (Q), motivating a careful study of the microscopic origin of the remaining losses that limit their performance. We have recently shown that the losses in Ta-based resonators are dominated by two-level systems at low microwave powers and millikelvin temperatures. We also observe that some devices exhibit loss that is exponentially activated at a lower temperature inconsistent with the superconducting critical temperature (Tc) of the constituent film. Specifically, dc resistivity measurements show a Tš of over 4 K, while microwave measurements of resonators fabricated from these films show losses that increase exponentially with temperature with an activation energy as low as 0.3 K. Here, we present a comparative study of the structural and thermodynamic properties of Ta-based resonators and identify vortex motion-induced loss as the source of thermally activated microwave loss. Through careful magnetoresistance and x-ray diffraction measurements, we observe that the increased loss occurs for films that are in the clean limit, where the superconducting coherence length (š) is shorter than the mean free path (š). Vortex motion-induced losses are suppressed for films in the dirty limit, which show evidence of structural defects that can pin vortices. We verify this hypothesis by explicitly pinning vortices via patterning, and we find that we can suppress the loss by microfabrication.
